Ignition System

Replacement cap for the 4-cylinder 123 distributor. Keep a spare on hand! Ref: VK105, GDC123E.

All new, fully electronic billet distributor for A+ engines. Programmed with 16 advance curves to choose from. Ref: C-27H7772.

All-new, fully electronic billet distributor for A+ engines. Programmed with 16 advance curves to choose from. Ref: C-27H7773.

All-new, fully electronic billet distributor for A-series engines. Programmed with 16 advance curves to choose from. Ref: C-27H7770.

All new, fully electronic billet distributor for A-Series engines. Programmed with 16 advance curves to choose from. Dwell is microprocessor controlled, depending on coil current. Works with any standard or

FIA-approved battery cut-off switch; includes two universal keys and instructions. Ref: MW002.

Bolt used to secure the forked distributor retainer found on A+ engines from 1985. Ref: TAM1706, CAM6105.

A little flash for your engine bay! A nice stainless coil bracket to replace that dull original one. Easy and inexpensive, an ideal gift item.

Mounting bracket for Pertronix ignition coils, in a bright chrome finish. Ref: PER10002, 10002.

Mounting bracket for Pertronix ingition coils, zinc in a matte finish. Ref: PER10001, 10001.

Plastic-bodied cam timing sensor for engine management of MPI Minis. Fits in mechanical fuel pump hole in the block. Genuine Lucas product.

Used-condition A+ coil bracket that mounts on cylinder head stud. Ref: 12G2994, U-12G2994.

Coil bracket fitted to end stud of cylinder head, as used 1969-1996. Ref: 12G2994.

Ignition coil pack for MPi (multi-point injection) classic Minis. Ref: GCL204, GCL0204, GCL302.

High-output ignition coil, as originally used with electronic ignition classic Mini models. Ref: DLB198, GCL143, GCL211.

Chrome PerTronix Flame-Thrower ignition coil for classic Minis with a ballast resistor in the ignition wiring, typically 1984-1996.

This black 40,000 volt Flame-Thrower ignition coil is a perfect complement to the Pertronix inductive Hall Effect distributor module.

This chrome 40,000 volt Flame-Thrower ignition coil is a perfect complement to the PerTronix inductive Hall Effect distributor module.

Black PerTronix Flame-Thrower ignition coil for classic Minis with ballasted ignition system, typically 1984 to 1996 range.

Oil filled for better cooling and voltage insulation. 3 ohm resistance as used on Minis up to 1984 without an external ballast resistor in the ignition wiring.

Condensor to fit 25D distributors, found in classic Minis up to 1974. Ref: DCB101C, DCB101, GSC2111.

Condenser, fits every Lucas distributor 1974-on. Sold each.

Some A+ engines were fitted with Ducellier distributors, which required special ignition parts, such as this condenser. See also DDB221 cap, DSB218 points, and DRB229 rotor.

Long-pin base plate for mechanical advance 23D and 25D distributors. Uses DSB109 points. Ref: 54412436, 7H6949.

Distributor cap retaining clip for 1974-on 45D series distributors. Fits DDB108/GDC136 caps. Ref: GDC136CLIP.

Top-exit distributor cap for Lucas 45D distributor, 1974 to 1990. Ref: GDC136, DDB108.

Distributor cap for 23D and 25D pre-A+ distributors, with side-exit terminals. Ref: DDB101, GDC102.

Top-exit distributor cap for 23D and 25D distributor. Ref: DDB106, 54417214, DC6, GDC103.

Distributor cap for Ducellier A+ distributor. Top exit. Original caps were red, but replacements will be either red or black, depending on supplier.

Cap for Lucas 65D electronic distributor; held on with screws. Ref: GDC156, DDB182, 54402806.

Non-standard side-exit push-in distributor cap for Lucas 45D distributors. Ref: DDB194, 54400270, DC94, GDC142, NJD000142EVA.

Rubber waterproofing boot for the early, side exit distributor cap as used on 25D distributors found on the classic Mini 1959-1973. Ref: 8G726, 8G0726.

Drive spindle for A+ distributors only. Ref: 12G3560.

Drive spindle that fits distributors on A+ engines only. Used. Ref: 12G3560, U-12G3560, 12G3560-USED.

Good-condition used distributor drive spindle/gear for A-series engines only. Ref: 12G4499, U-12G4499, 12G4499-USED.

This is the later A+ distributor retainer, introduced with the ''black box'' electronic distributor. Ref: TAM1671.

A nice laser-cut stainless steel hold-down clamp for points-type A+ distributors, with graduated markings for advanced calibration.

Replacement clamp for all distributors used on A-series (not A+) classic Mini engines. Ref: 3H2138, 501134, 421191.

Used distributor mounting base/adapter; slides into A-series 850cc, 997cc, 998cc, 1098c or 1275cc blocks. Ref: 12A1136, U-12A1136, 12A1136-USED

59D points-type distributor for 1275 A+ engine, including Metro. Complete assembly including cap, rotor, points and condenser. Ref: ADU3825.

23D mechanical advance A-series distributor, fitted with a top-exit cap. Ref: 12G2140.

A brand-new distributor with the looks of the Lucas 25D distributor, but with maintenance-free electronic ignition. Ref: GEU930MS, 25D4E.

Modern Japanese electronics have been combined with the Lucas 45D4 Distributor to give you the best of both worlds, maintenance-free ignition with the original look of your British Distributor. Ref: 41427, 41427E, 45D4E.

59D points-type distributor for A+ 998cc, 1981-1989. Ref: ADU5789, AAU9142, 59D4.

Used Lucas 59D series points distributor for A+ blocks. With vacuum advance unit.

A+ Distributor with electronic ignition; evolution curve to give best performance on classic Minis with standard camshaft up to to 276 spec. Ref: C-27H7701.

Advanced electronic distributor for your A+ classic Mini. Ref: 59D4E, ADU3825MS.

A+ distributor with electronic ignition; evolution curve to give best performance on classic Minis with 286-296 performance camshaft. Ref: C-27H7702.