Search Results for "alternator"

Alternator that fits any alternator-setup classic Mini, excluding fuel-injected models. Ref: LRA100, GXE2211, GEU207. ... [SEE MORE ]

Special short bracket for the rear of an alternator when longer, non-standard alternator is fitted. Ref: 12G1053, FOR084. ... [SEE MORE ]

Curved adjusting link to the lower bracket for use with alternator. Ref: 12G2627. ... [SEE MORE ]

Classic Minis used this higher output alternator from 1985-on; direct bolt-in replacement for alternators used on earlier models. Ref: GXE2276, GXE2297. ... [SEE MORE ]

Classic Mini alternator, as fitted from 1996-on only, with brackets that will only fit the MPi cylinder head. Ref: LRB370, GNU2521, GXE2862, LULRB370. ... [SEE MORE ]

Original bracket for pre-A+ engines to mount the rear of the alternator when converting from a generator to an early Lucas alternator. Ref: 12G1053. ... [SEE MORE ]

Complete harness for 1963-67 Mk1 classic Mini 850 Super, Deluxe and Cooper models with 3-gauge center pod. ... [SEE MORE ]

Replacement electrical plug kit for alternator; includes wire terminals and plastic plug. Ref: CYB400, AYB400, GEU250, 54960402, 60600983. ... [SEE MORE ]

Rear bracket used to mount an alternator in the earlier classic Minis; fits any A-series or 1300cc engine block. Ref: 12G1053, FOR079. ... [SEE MORE ]

Stamped steel cooling fan for early alternator with 14mm shaft. Ref: C37222, C37222A, 54202055. ... [SEE MORE ]

Metal cooling fan for classic Mini alternators without a keyway on the shaft, typically 1980-1996; used condition. Ref: AUU1097. ... [SEE MORE ]

Drive-end bearing and slip ring kit for Lucas 16ACR, 17ACR, and 18ACR alternators. Ref: UMB109, 18G8620, 54219312. ... [SEE MORE ]

Fan belt for use with standard, small water pump pulley and alternator. Made in England. Ref: GCB10813, QBA813. ... [SEE MORE ]

Original factory patterns were used to create this wiring harness for the Mk1 Cooper S fitted with alternator. Ref: 326ALT, 5L672. ... [SEE MORE ]

Mounts to the front engine plate to allow adjustment of the generator or alternator belt ... [SEE MORE ]

Fan belt for use with standard small water pump pulley and alternator or generator with small pulley. Ref: 9.5X825, GCB10825. ... [SEE MORE ]

Complete harness that fits Mk2 Cooper S with alternator; braided black cotton covering with yellow flashes. Ref: 327ALT, 5L692, 5L0692, WL307, WL327-ALT. ... [SEE MORE ]

Complete wiring harness for the UK-made Austin Mini Moke, 1964-66 approximately. Made to original patterns with proper wire colors and fittings, but modified for used with alternator. ... [SEE MORE ]

Complete wiring harness for the 1960-62 Van & Countryman. Made to original patterns with proper wire colors and fittings, but modified for used with alternator. ... [SEE MORE ]

Serpentine belt for 1997-on MPi (multi-point injection) classic Minis. Ref: GMB50920, PQS050925EVA, GMV50925. ... [SEE MORE ]

127'' length cable that runs from the battery to the solenoid. Suitable for negative or positive ground cars. Ref: YTA10037. ... [SEE MORE ]

For race applications when the alternator/generator is removed. Use with large diameter water pump pulley and standard diameter crank pulley. Made in England. ... [SEE MORE ]

Original factory patterns were used to create this complete wiring harness for the 1972-1975 classic Mini Clubman. This model was equipped with alternator, but no tachometer. ... [SEE MORE ]

The smaller of the two generator pulleys originally used on the classic Mini, and gives the highest charging rate at lower RPM. Ref: 12G1054, 12A1772. ... [SEE MORE ]